ALU Retro Shooter Integration Kit
Installation Guide:
Please Note: The supplied toggle switch that comes with the kit is for the Recoil Power Kit. The switch used to connect to the Retro Shooter Console, as shown in the video below, is the power switch supplied with the Retro Shooter Kit. If you have a newer Console, your power button will be integrated right into the console - there is no longer a separate switch.
Here is the full install video:
If you have the 4 IR Gun Kit from Retro Shooter (shipped after Nov 15, 2023) then you will need to use all 4 IR modules which is NOT shown in the video above.
You can either 1) drill the bezel to install IR #3 and #4 - Please be careful drilling in the bottom left corner as you need to loosen the the CPU board in the back to avoid hitting it.
or
2) wrap it between the control deck as shown below:
We have now released a Power Harness Cable that can be used if you would like the IR Modules to turn on and off with the ALU power button.
Simply unplug the marquee cable in your CPU board and insert our adapter in-between. The marquee will still light up and anything plugged into the standard 5.5mm x 2.1mm barrel plug will turn on and off with the ALU power switch. See pics below:
Simply unplug the marquee cable in your CPU board and insert our adapter in-between. The marquee will still light up and anything plugged into the standard 5.5mm x 2.1mm barrel plug will turn on and off with the ALU power switch. See pics below:
To integrate your ALU controls with the Retro Shooter Console, this video will give you some tips on mapping the controls.